1

Production materials

2

Boiler fuel type

coal-fired boiler

gas boiler

Solid waste boiler

Incineration of household waste

Industrial waste incineration:

other

3

Smoke temperature

＜650 degrees

Other temperatures:

4

Measurement point pressure magnitude

positive pressure

negative pressure

Specific values:

5

Do you need wear resistance

6

Installation direction of probe

horizontal installation

vertical installation

Others:

7

Oxygen probe insertion depth

L=mm (insertion depth refers to the length below the flange)

8

Explosion-proof rating

Not explosion-proof

BT4

BT6

CT4

CT6

other

9

Flange Specification

standard configuration

Other Specifications

10

Direction of flange installation hole

X-shaped

Ten types

Others:

11

Installation method of analyzer

Wall mounted

Plate mounted horizontal

Plate mounted vertical

Plate packing table

Others:

12

Analyzer range

0-25%

Others:

13

If purchasing oxygen probes separately and using them in conjunction with analyzers from other manufacturers, it is necessary to measure the resistance value of the heating furnace of the original oxygen probe.

Instructions:

1. Check the correct items and mark them in the black box.

2. The standard flange specification refers to a flange outer diameter of 155mm and a center hole distance of 130mm for installation holes.

3. The direction of the flange installation hole refers to the diagonal connection of the screw holes when viewed from the flange installed on the furnace wall, as shown in the following figure.

4. Wall mounted 260 * 200 * 100mm. Horizontal: 160 * 80 * 160mm, vertical: 80 * 160 * 160mm. Square meter: 160 * 160 * 160mm.