The magnetic flap level gauge can be directly used to observe the liquid level height of various media in containers. It is suitable for liquid level indication in industries such as petroleum and chemical. The liquid level gauge has a simple structure, intuitive and clear observation, no blockage or leakage, easy installation, and simple maintenance. The upper and lower ends of the glass plate level gauge are connected to the container by flanges, forming a connector. The actual height of the liquid level in the container can be directly observed through the glass plate. The upper and lower valves are equipped with safety steel balls. When the glass is accidentally damaged, the steel balls will automatically seal under the pressure inside the container, preventing liquid from overflowing and ensuring the safety of operators.

What should I do if the magnetic flap level gauge is too long?

For those exceeding a certain length, it is necessary to add intermediate reinforcement flanges or ear hooks as fixed supports to increase strength and overcome their own weight; The installation position of the magnetic flap level gauge should avoid or be far away from the inlet and outlet of the material medium to avoid rapid changes in the local area of the material fluid, which may affect the accuracy of the level measurement; When equipped with remote transmission supporting instruments, the following requirements should be met: the zero position of the remote transmission supporting instrument should be on the same horizontal line as the zero position indication of the liquid level gauge; The connection between the remote transmission supporting instrument and the display instrument or industrial control computer is best laid separately through a protective tube or with a shielded two core cable; The remote transmission supporting instruments should be tightly attached to the main pipe of the liquid level gauge and fixed with stainless steel clamps (iron is prohibited); The sensing surface on the remote transmission supporting instrument should face and be closely attached to the main pipe; After the wiring holes of the junction box are laid, it is required to be well sealed to prevent rainwater, moisture, and other factors from entering and causing the remote transmission supporting instruments to malfunction. The junction box should be promptly covered after maintenance or debugging is completed.