Wire and cable are highly popular in modern production and life, and any machinery that requires electric drive cannot do without the support of wire and cable.

The main components of wires and cables are metal wires, insulation sleeves, and protective sleeves, which require strict and cautious transportation and storage of wires and cables to avoid damage during transportation and storage.

During transportation, it is necessary to avoid the phenomenon of wires and cables falling from heights. It is also prohibited to throw wires and cables from heights during loading and unloading, especially under low temperature conditions. The insulation and protective sleeves of wires and cables are brittle and hard, and falling from heights can cause the insulation and protective sleeves to crack.

The insulation and protective covers of wires and cables are mostly made of rubber products and cannot withstand excessive sunlight exposure. Therefore, it is necessary to avoid placing wires and cables in open areas as much as possible, and cable reels are not allowed to be laid flat.

When packaging 3 wires and cables, it is not allowed to hoist several cable reels at the same time to avoid dangerous accidents. The placement of cable reels on transportation vehicles such as vehicles and ships must be reasonable and fixed to prevent the cable reels from tipping over or colliding during transportation, causing damage to wires and cables.

Wires and cables generally have poor corrosion resistance and are strictly prohibited from coming into contact with acidic, alkaline, mineral oil substances. If they must be placed in close proximity to corrosive substances during transportation, necessary isolation must be carried out. The storage warehouse for wires and cables must prohibit the presence of substances that damage the insulation protection layer of wires and cables, as well as corrosive gases.

If the storage time of 5 wires and cables is long, it is necessary to roll the cable reel appropriately. The rolling cycle is about three months, and the specific time can be set according to the situation. During the rolling process of wires and cables, attention should be paid to rolling the downward stored edge to the top, which can prevent the edge of a certain part of the coil from being located below for a long time and becoming damp and rotten.

6. Wires and cables are also products with a shelf life. Generally speaking, wires and cables are used within their shelf life. If the shelf life has expired, it should not exceed one and a half years, and the longest shelf life should not exceed two years. During the storage process, it is necessary to regularly check whether the heads of wires and cables are intact and undamaged.