Instructions for using the SKH-40 series blender

Standard mixerMISUGIelectric blenderSKH-40CA

Electric mixer, standard mixer,SKH-40seriesSKH-40SA，SKH-40SX，SKH-40PA，SKH-40PX，SKH-40CA，SKH-40CX

Product Introduction

electric blenderSKH-40series

A simple mechanism that can even dirty containers! mix and stir

Although the structure is simple, even the ink inside the container can mix well. You don't need to spend a lot of wasted money.

100VHousehold power supplyOK！40WSmall motor, energy-saving.

Consistent material quality and reduced defects.

Due to the absence of stirring blades, there is no need for preparation or cleaning work, greatly reducing labor.

Due to the uncut top plate, the remaining materials can be stored as they are after use, eliminating waste.

can be used for

Paint, ink, oils, adhesives, glazes, etc

Chemicals, metal powders, soy flour, hot cake powder, etc

Resin particles, beans, rice, pet food, etc

Tea leaves, materials with different densities, etc

Efficient design, eliminating waste

The three-dimensional motion and automatic forward and backward rotation of the content achieve uniform mixing, stirring, and dispersion in a very short time.

Easy to put on and take off, simple to operate! Improve economic efficiency by setting the number of processes

SKH-40The series can be easily operated through the control panel at the top of the main column (the position of the control panel can be changed by making a separate product).

All you need to do is press the start button.

Automatically stop when the number of processes is selected. adjustable1、2、4、8、16Step or continuous. A process means turning forward15time/reverse15Next time（50Hz: About43second/60Hzabout37Seconds) and automatically stops.

At the end of the process, it always stops at the installation of the container/Dismantling position.

The installation position of the tank (container) is low, making it easy to load and unload.

passThe combination of "standard machine" and "gasket" can handle an unlimited number of containers (limited to containers smaller than the main support) by preparing gaskets according to the container.

The gasket will be manufactured according to the container.