GB10004 Pressure resistance test for multi-mode optional packaging bags. The materials for syrup packaging bags include polyethylene film, aluminum foil, and paper packaging paper. Today we will mainly learn about polyethylene film packaging bags. Polyethylene film is a common candy packaging paper material with good barrier properties, which can effectively block moisture and oxygen, and maintain the freshness of the contents. Polyethylene film also has certain tear resistance and provides some protection. This article is about Shandong Puchuang Industrial Technology Co., Ltd. providing pressure resistance testing for polyethylene film syrup packaging bags according to the testing standard of National Standard 10004.

Testing instruments:SCT-E1 packaging pressure tester

Testing requirements:

Fill the bag with about half the capacity of water and seal it. There are 5 samples. During the experiment, place the samples one by one between the upper and lower plates. During the experiment, the upper and lower plates should be kept level and not deformed. The contact surface with the bag should be smooth, and the area of the upper and lower plates should be larger than that of the test bag. Add weights according to Table 8 and hold for 1 minute (the load is the sum of the weight of the pressure plate and the weight), visually inspect whether the bag is broken or leaking.

Equipment mode: pressure holding mode, rupture mode, attenuation mode, multiple testing modes

Operation steps:

Connect the device to the power supply, click to enter the operation interface

Select the holding mode, set parameters, speed mm/min: 5, test force value N: 100, holding time s: 30

Test results:

Production batch number: 1

Test speed mm/min: 5.0

Test force value N: 100.0

Test force value kg: 10.4

Pressure holding time S: 30