Festo FESTO Exhaust Valve Order Number 548713

Festo FESTO Exhaust Valve Order Number 548713

• Measurement range: Connecting rod: 100 750 mm inertia compensator: 225 .. 2000 mm • Pre assembled cable ensures error free and fast operation

Connection sensor interface CASM • Application areas: Soft Stop and pneumatic positioning, used for cylinder bore 25 .. 80 mm， For example, DNC or DSBC

• Load range 1 300 kg • Easy installation and quick debugging • Cost effective • Can also be used in harsh working conditions • Multiple cylinders: CPX-CMPX and CPXCMAX also support cylinders with external displacement encoders, single component for positioning, with servo positioning controller SPC11. DGPL, Equipped with circulating ball bearing guide rail [1] servo positioning controller SPC11-POT-TLF [2] proportional directional control valve MPYE [3] rodless cylinder DGPL

[4] Connecting cable KMPYE AIF -... • Cylinder diameter @ 25 63 mm • stroke 225 .. 2000 mm • Standard or extended slider

• High characteristic load value • Gas interface located on both sides of DGPL, with circulating ball bearing guide and clamping unit • Cylinder diameter @ 25 .. 40 mm

• Trip 225 .. 2000 mm • Standard or extended slider • In the event of loss of pressure, clamping units can be used to secure the slider in vertical applications

• High characteristic load value • The air interface is located on both sides of the rodless cylinder, with a slider and an external displacement encoder [2] hydraulic buffer component YSR/KYP

When a malfunction occurs, in order to prevent damage to the terminal block [3], groove nuts are used for the slider to install loads and accessories on the slider for locating loads and accessories on the slider. Used to position the load and accessories on the slider, the one-way throttle valve GRLA is used to adjust the speed, and the proximity switch SME/SMT is used

Additional detection for piston position, optional, can only be combined with the ordering code in the cylinder modular product system

Displacement encoder installation positions MA1... MA4/MP1... MP4 are used to measure the position of the cylinder - adapter for cylinder/claw connection

The force and torque shown in the technical parameters are referenced to the centerline of the cylinder bore. These values must not be exceeded during dynamic operation. Special attention must be paid to the buffering phase. If the cylinder receives multiple forces and torques simultaneously, in addition to the maximum load shown, it must also satisfy the following equation.