HL-CYB600 differential pressure transmitter

Technical parameters, pressure parameters, electrical connections

Instruction Manual

Differential pressure transmitter overload static pressure range 0~3bar ≤ 20MPa 2 times full range pressure positive pressure end (take the minimum value) 1 times full range or 1MPa negative pressure end OUTTEST+terminal TEST OUT+two-wire power supply 24V positive air air 4-20mA signal common terminal: GND power supply 24V positive three wire air 0-10V signal positive

Pressure type differential pressure

Pressure connection NPT 1/4 external thread, M20 * 1.5, G1/2 external thread,

00000 accuracy ± 0.5% FS (typical) performance parameter sub definition: 4-20mA two-wire output

Long term stability maximum ± 0.3% FS/year+pnalale definition

Zero temperature coefficient 0.03% FS/C (>100kPa) 0.05% FS/C (≤ 100kPa); OUT+power supply positive/+V

Full temperature coefficient 0.05% FS/C (≤ 100kPa); OUT - Output positive/+OUT

0.03%FS/C(>100kPa)

environmental conditions

Storage temperature Operating temperature -30 ℃~80 ℃ -40 ℃~125 ℃ Reset operation

Overview: The HL-CYB600 differential pressure transmitter encapsulates the differential pressure sensor in a liquid crystal display product that stores refrigerant or water, electricity, and gas parameters. In the measurement state, the instrument is at zero, but

Constructed within the stainless steel casing of the positive and negative chamber pressure interfaces. It selects the output type of current type and voltage type, and the display is not zero, which means the instrument has zero drift. According to S school

High stability and reliability differential pressure sensors and high-performance transmitters with power supply ranging from 12~30VDC to 15~30V DC. The zero key should be pressed for more than 3 seconds to prevent false zero calibration

Reliable dedicated circuit, realizing the conversion of differential pressure and electrical signals, with stable overall performance output signal (two-wire system) 4-20mADC (three wire system) 0/1V-5/10VDC display "-00-", and instrument zero calibration.

Widely applicable to various loads in pipelines such as petroleum, chemical, power, hydrology, etc., with resistance ≤ (U-9)/0.02 ≥ 10k

Differential pressure measurement of gases and liquids. structural parameters

Product features: All stainless steel structure design, small size and light weight, easy installation. The shell sensor is made of cast aluminum and 316 stainless steel. The product is shipped within 12 months from the date of shipment

After temperature compensation and aging screening, the performance is stable and reliable, and the shell protection is IP65. For returns, our company will provide free replacement. For customer reasons

If the electrical connection M20 * 1.5 with short-circuit protection and reverse polarity protection causes performance degradation or damage, our company will charge for repair or replacement.

High precision, high stability, and high reliabilityNote: It is strictly prohibited to install torque greater than 25N. m.