09,22,2026 18 views
Recently, the central safety production assessment and inspection for the year 2025 have been officially launched,22 central safety production assessment and inspection teams led by relevant member units of the State Council Work Safety Committee have successively entered 31 provinces, autonomous regions, municipalities directly under the central government, and Xinjiang Production and Construction Corps to conduct assessment and inspection of safety production work in 2025, which will be completed by the end of November. As of November 10th, 10 central safety production assessment and inspection teams have been stationed in Shanxi, Heilongjiang, Liaoning, Jiangsu, Jiangxi, Hainan, Chongqing, Yunnan, Gansu, and Xinjiang to carry out work.
Central safety production assessment and inspection, open and covert investigationsthe first batchThe on-site inspection issues have been exposed, involving gas leaks and gas detection alarm devices in multiple fields!
1The safety director of the liquefied gas station is not clear about the explosion limit of liquefied gas
The assessment inspection team conducted a night inspection of a liquefied petroleum gas station. The assessment and inspection team found on site that the safety production system and training at the station were incomplete. It is worth mentioning that when faced with on-site questions from the assessment and inspection team experts, the safety director of the station gave an incorrect answer of "higher than 45%, lower than 16%" regarding the explosion limit of liquefied petroleum gas of 1.5% to 9.5%, and no one in the station could accurately answer.Through further inspection of the on-site equipment, the inspection team found that the pump room equipment at the station was leaking air. After testing, the leakage value of the pump has exceeded the upper limit displayed by the detector.
2The staff at the liquefied gas station are not proficient in using leak detectors
At a liquefied gas station in Gannan Prefecture.The assessment and inspection team also detected a leak in the hydrocarbon pump in the pump room of the station, and the gas leak detection equipment equipped in the station did not meet the requirements——Two liquefied gas stations use methane and general combustible gas leak detection equipment respectively, and the correct selection should be liquefied petroleum gas or propane leak detection equipment. Experts point out that although methane detectors may sound an alarm, it can easily lead to probe "poisoning" and malfunction, affecting detection accuracy. Meanwhile,The liquefied gas station only has one leak detector, and the personnel at the station are not proficient in using it.
3Security management is perfunctory! Enterprise leaders and safety managers are not familiar with relevant regulations
The assessment and inspection team found problems such as inadequate implementation of safety responsibilities in a certain food limited liability company during open and covert investigations in Gansu.
In terms of the construction of safety regulations, the assessment and inspection team found that the enterprise had perfunctory behavior. Although a third-party company was asked to prepare relevant regulations, the regulations were not combined with the actual situation of the enterprise. The enterprise leaders and safety managers did not understand the relevant regulations, let alone use and implement them.
For example, in the company's "Safety Production Management System", section 2.10 is "responsible for setting annual concrete supply targets". The assessment and inspection team experts asked the enterprise safety manager why there was content unrelated to the main business of the enterprise, but the enterprise safety manager did not give a direct answer.
In addition to the above-mentioned issues, the assessment and inspection team also found that the company's new project safety production "three simultaneities" have not been reported and filed with relevant departments; There is no call button installed near the entrance of the cold storage, and there is no call signal displayed outside the cold storage;The combustible gas alarm controller in the gas boiler room showed leakage values from two probes, but did not investigate and promptly eliminate potential safety hazards.
4The installation position of the monitoring and alarm device is incorrectAnd it is not interlocked with ventilation facilities
In a certain liquor industry,Some workshops of the distillery are equipped with ethanol vapor concentration monitoring and alarm devices, but the probe installation position is incorrect and not interlocked with the ventilation facilities; However, there are no fixed ethanol vapor concentration monitoring and alarm devices installed in key areas such as the filling workshop and wine storage.
Experts from the assessment and inspection team stated that the specific gravity of ethanol vapor is greater than that of air, and according to relevant requirements, the alarm should be installed at a height of 30-60 centimeters above the ground,But the installation position of the alarm in the distillery is too high, and some are even close to the roof, which cannot provide an alarm function.
There are also some problems in the liquor industry, such as insufficient fire separation between Baijiu storage tank farm and buildings, no automatic fire alarm system in Baijiu finished product warehouse, and no fire control room.
5Stacking gas cylinders layer by layer
The assessment inspection team required the main person in charge of a certain gas limited company to open the rolling shutter door in the bottle storage area during the inspection. As soon as the door rose, I saw a dense array of liquefied petroleum gas cylinders stacked upside down against the wall, with a total of 7 layers.
Don't you know how to safely stack gas cylinders? "The assessment and inspection team expert asked the main person in charge of the enterprise.
According to the requirements, they must be stacked upright, but these are all scrapped gas cylinders... We will change them immediately! Change them immediately! "The main person in charge of the enterprise quickly understood the problem.
Beside the stacked gas cylinders, the combustible gas alarm probe that was supposed to constantly monitor leaks was wrapped in a white plastic bag.The expert stepped forward to remove the plastic bag and found that the explosion-proof pipe connecting the alarm was also loose and had lost its explosion-proof function.The assessment inspection team immediately opened the doors of the two warehouses on the left, which were also filled with liquefied gas cylinders and did not have combustible gas alarms installed.
警示
The central assessment and inspection revealedthe first batchThe problem, hitting the critical link of gas safety risks, once again sounded the alarm for all industries!
The alarm bell rings long, action is imminent! All production and operation units must immediately carry out self-examination and self correction:
Check if there is:According to the standards, ensure that all places with gas leakage risks (such as storage tank areas, valve groups, pipeline flanges, enclosed spaces, paint booths, laboratories, etc.) have installed applicable and qualified gas detection alarms.
Confirm 'not working properly':Regularly verify and calibrate the alarm to ensure its sensitivity and accuracy, and strictly prohibit equipment from operating with defects.
Verify whether it will sound:Regularly test the alarm function to ensure that the alarm signal is clear and effective, and relevant personnel are familiar with the alarm handling process.
Safety is no small matter, responsibility is greater than heaven.Choosing Yao'an gas alarm is choosing a professional and reliable safety guarantee.It builds a solid gas safety defense line for enterprises with its precise monitoring, stable performance, and timely alarms, ensuring the steady development of enterprises is protected 24/7.
