Can be integrated into the control cabinet multi parameter analyzer

Can be integrated into the control cabinet multi parameter analyzer

Model: MPG-5199Mini

Wall mounted, simultaneously measuring water temperature pH、 Residual chlorine and turbidity.

Temperature: 0-50

PH：0-14PH

Residual chlorine: 0-20mg/L

Turbidity: 0-20NTU

220V power supply, 485 output. Adopting 304 stainless steel shell, 4-inch touch screen, left USB interface for exporting data, size: 360 * 190 * 165mm

productfeature

1. Integrated products, convenient transportation, simple installation, and small footprint;

2. Can achieve personalized customization，Flexible combination, selection, and customization of corresponding monitoring parameters based on customer monitoring needs；

3. By monitoring and storing data, achieve intelligenceonline monitoring；

4. Integrate and simplify complex on-site issues；

5. Easy maintenance, notprofessionalall acceptableMaintain this product

Installation requirements

Installation environment: Avoid direct sunlight, no strong magnetic field interference around, stay away from high temperature and humidity environments and places with large temperature differences;

Pressure of incoming water:≤0.3Mpa

Traffic requirements:30 L/h-50L/h

Anti interference prevention measures: Do not mix with the electric motorFrequency converterShare one power supply with other high-power devices.

Ensure smooth flow of water and stable power supply.

Turbidity sensor description:

Discharge valve: When first used,Please firstOpen the drain valve,Perform flushing（5About minutes).

The instrument collects water samples from the inlet and discharges them from the outlet. The installation position of the instrument should be

Water measurement

1. liquidity poolrinse：Open the inlet valveAt the same time, openliquidity poolDrain the accumulated water in the front-end pipeline with a drain valve (approximately)10Wait until the water quality is relatively clean and there is no obvious dirt, then close the drain valve;

2. Turbidity measurement tank flushing：After being powered on,pleaseOpen the drain valve and flush5After minutes and no obvious dirt, close the valve.

3. normalMeasurement:Open the inlet valveClose the drain valve and ensure that there is a small amount of water at the overflow outlet of the circulation pool, which can flow out normally.

Can be integrated into the control cabinet multi parameter analyzer

Multi parameter water quality detector for tap water outlet

Multi parameter detector for simultaneous measurement of pH, residual chlorine, turbidity, and temperature

Multi parameter measuring instrument for simultaneous measurement of pH, residual chlorine, turbidity, conductivity, dissolved oxygen