Electric dust removal U-shaped heater JGM 380V2KW

Injection molding machine hydraulic cylinder test bench hydraulic electric heater HRY3 380/2

Electric heater SRY6-2-4KW-22VSheath type electric heater HRY5 220V/4KW*

Electric dust removal U-shaped heater JGM 380V2KWProduct Introduction

There are various specifications for surface load to choose from, and reasonable selection can prevent oil carbonization and burning; Safe and reliable, extending the service life of the medium. The installation holes for SRY5-I type are diameter 65, SRY5-II type are diameter 90, and SRY5-III type are diameter 120. The A.B size of various specifications of heaters can be customized according to the usage environment.

Product Usage

Electric heater SRY6-2-4KW-22VSheath type electric heater HRY5 220V/4KW* Mainly used for heating media in hydraulic lubrication, it can also be used to heat non corrosive gases.

Injection molding machine hydraulic cylinder test bench hydraulic electric heater HRY3 380/2Material

The general materials for the outer tube include In800, In840304, 316L, 310S, aluminum, copper, low-carbon steel, etc.
Magnesium oxide powder is selected in different specifications according to different usage requirements, including high-temperature powder, medium temperature powder, etc.
Resistance wire is a heating element, and there are generally two types of materials: Ni Cr wire and Fe Cr Al
There are generally two types of lead terminal materials: stainless steel and easy to cut iron.
Sealing materials include epoxy, silicone, glass, etc.

Electric dust removal U-shaped heater JGM 380V2KWDaily maintenance:

1. After the heater has been running for a period of time (depending on the user's usage), the ignition plug should be unscrewed to clean the carbon deposits. If the ignition plug wire burns out, it should be removed and replaced with a new one.
2. If there is too much carbon deposition, causing a decrease in thermal efficiency, the carbon deposits on the inner wall of the water jacket and the combustion chamber should be cleaned.
3. If you find that the intake pipe, exhaust pipe, and drip pipe of the heater host are blocked by soil, please clean and unclog them in a timely manner. Please keep the heater compartment clean and do not place flammable debris around it.
4. Ensure the cleanliness of the fuel tank, oil pipe, and oil filter solenoid valve to prevent dirt from blocking the oil circuit.
5. Antifreeze suitable for the external ambient temperature should be used as the circulating heating medium in the heater circulation system.
6. The heater water pump should be regularly inspected according to the user's usage situation. If any leakage is found in the water seal component that plays a sealing role, or if the water pump is difficult to start and operate, it should be repaired in a timely manner.
7. The automatic control box, oil filter electromagnetic fan, and other electrical components on the heater host are maintained according to general low-voltage electrical maintenance methods. The performance parameters of the automatic control box have been carefully debugged by the manufacturer before leaving the factory, and users must not make unauthorized changes.
8. Ensure that the thermal control is in good condition and regularly check. If the micro switch is found to be malfunctioning or damaged, please replace it in a timely manner.
9. The main motor commonly used in heaters does not require maintenance after 5000 hours of use under normal circumstances. If it malfunctions due to prolonged use or other reasons, it should be inspected for carbon brush wear or bearing lubrication. If necessary, lubricating grease should be added or carbon brushes replaced.
10. During the warm season when the heater is not in use, please start it 4-5 times regularly and run it for about 5 minutes each time to ensure that the heater operates normally during the next use.