P+F photoelectric encoder PVM58N-011ARG0BN-1213

P+F photoelectric encoder PVM58N-011ARG0BN-1213

Installation and debuggingAccording to the working conditions, the relevant equipment must meet at least the requirements of IA protection level and Group II or III requirements. Due to the risk of fire caused by faults and/or transient currents in equipotential bonding systems, it is best to provide current isolation in power and signal circuits. Equipment without current isolation can only be used when the relevant requirements specified in IEC 60079-14 are met. This certificate does not guarantee that the components installed in the partition will isolate each area from each other. When setting up partitions, appropriate measures must be taken to ensure individual isolation.

maintenanceDo not make any modifications to equipment used in hazardous areas. Repair of such equipment is not allowed.

special conditions

Prevent dangerous static electricityDuring equipment installation, it is necessary to ensure that static discharge can be avoided. If the equipment is installed according to the manufacturer's instructions, given the nature of the equipment, it should not generate dangerous electrostatic discharge.

Prevent mechanical hazardsWhen the sensor is used in a temperature environment below -20 ° C, it should be protected from the impact of the additional housing.

The required level of protection when installing connecting componentsIP20 complies with IEC 60529:2001

Other conditionsPlease refer to the relevant EC type inspection certificate for the circuit type of connection, maximum allowable ambient temperature, and surface temperature level. In applications with high charges, such as electrostatic spraying, metal foil manufacturing, dust removal, and mechanical friction, structural measures must be taken to limit the surface area of the plastic shell in contact with this charge to approximately 15 cm2 to avoid increasing brush discharge. When setting up partition walls between different zones, reasonable measures must be taken to ensure that the components installed inside the partition walls can isolate the zones.

P+F photoelectric encoder PVM58N-011ARG0BN-1213