Shanghai Programmable Salt Spray Corrosion Test Chamber

NegotiableUpdate on 12/20

Model

Nature of the Manufacturer: Producers

Product Category

Place of Origin

Online Consult

Overview

The Shanghai Programmable Salt Spray Corrosion Test Chamber is capable of conducting accelerated corrosion performance change tests on electrical equipment, metal materials, and products such as plating and coating. Related salt spray tests can be conducted according to standards such as GB/T2423.17 "Environmental Testing for Electronic and Electrical Products - Ka: Salt Spray Test Method", IEC60068-2-11 "Basic Environmental Testing Procedures Part 2: Tests, Tests Ka: Salt Spray", and ISO9227 "Artificial Simulated Climate Corrosion Test - Salt Spray Test". Acetic acid salt spray test can also be performed.

Product Details

Shanghai Programmable Salt Spray Corrosion Test Chamberreference standard
The relevant requirements for salt spray test method in GB/T2423.17 standard; The relevant provisions for product design and production in GB/T10587 "Technical Conditions for Salt Spray Test Chamber".
Shanghai Programmable Salt Spray Corrosion Test ChamberSystem Introduction
This series of salt spray corrosion test chamber is specially designed for testing the corrosion resistance of various materials after surface treatment such as painting, coating, electroplating, anodic treatment, rust prevention, etc. The salt spray spray tester is used to coat the test solution with a kind of corrosion test method by spraying the solution onto the film; It is an important testing equipment for the environmental adaptability and reliability of various products in industries such as materials research, national defense, automotive, light industry, electronics, and instrumentation.
1. Electrical capacity
Power supply: AC380V ± 10% 50Hz 3-phase 4-wire+separate grounding wire; Zui High Power: 11KW; Zui High Current: 25A; Air Switch Capacity: 32A
2. Standard accessories: Salt water tank: 1 (50L/piece); Mist collector: 2 pieces; Glass nozzles: 4; Installation and Use Manual: 1 set
3. Requirements for installation site
The distance between the front of the test box and the wall shall not be less than 800mm, the distance between the back and the wall shall not be less than 600mm, and the distance between the left and right sides shall not be less than 400mm. Users must provide independent distribution switches and sockets.
4. Limitations on test samples: Explosive substances, flammable substances, and samples containing the aforementioned substances with a biological heat generation exceeding the allowable limit
Structural characteristics of programmable salt spray corrosion test box body
1. Integrated structural approach
2. Glass fiber reinforced plastic FRP material insulation: hollow insulation
3. Stainless steel saturated drum humidifier (steam boiler humidifier)
4. Nickel chromium alloy electric heating wire heater, PID regulation, actuator: solid-state relay
5. High temperature resistant engineering plastic spray tower
Programmable Salt Spray Corrosion Test Chamber Control System
1. Armored platinum resistance temperature sensor, high-precision * Pt100.
2. Japanese digital LED "FUJI" temperature controller.
3. Indication accuracy temperature 0.1 ℃;
4. User program capacity comes with 8 segments of programs;
5. Fixed value operation mode;
6. PID balanced temperature control method (with PID self-tuning function);
7. The experimental data displays the set temperature and the measured temperature;
8. Time controller ANLY, programmable timer ATP-8S, can set interval spray cycle.
9. Pressure control: inlet pressure regulating valve, spray pressure regulating valve, pressure gauge.
10. spray pressure: 0.05~0.17 Mpa/cm * The air compressor shall be prepared by the user