Water plant oxidation disinfection equipment ozone generator manufacturer and Chuangzhi Cloud

Water plant oxidation disinfection equipment ozone generator manufacturer and Chuangzhi CloudThe raw gas does not contain hydrocarbons, corrosive gases, or any other substances that can react in oxygen/ozone/corona rings, thereby endangering or damaging equipment safety. *The three elements of an explosion are fuel, oxidizer, and spark, and two elements already exist in the corona environment of an ozone generator, namely oxidizer and spark. So it is necessary to prevent the raw gas from containing hydrocarbon fuel substances; If there may be hydrocarbons present, a hydrocarbon analyzer must be installed to cut off power when the concentration of hydrocarbons approaches the lower explosive limit (LEl) of 25%. Fluorinated carbon compounds, such as fluorocarbons or coolants, can decompose into fluorine during corona discharge, which can corrode glass dielectric materials and accelerate their destruction. The circulating cooling fluid outside the corona discharge room may leak into the corona discharge space through sealing, forming a paint film or coating on the surface of the dielectric material. If this situation occurs, it is necessary to regularly clean the dielectric, as the coating will reduce the efficiency of ozone generation. In addition, the raw gas should be filtered out of particles of about 5 microns to prevent small desiccant powder or other particles from entering the corona zone of the generator. Avoid the generation efficiency of corona.
2. The gas supply pressure cannot change uncontrollably. Due to the induction effect of air pressure on corona power and the influence of voltage changes between media, the generator's operation is unreliable, resulting in unstable generator operation. Exceeding the corona power range can cause the fuse or electrical appliance to automatically disconnect. Excessive voltage peaks can also lead to premature failure of dielectric materials.

Water plant oxidation disinfection equipment ozone generator manufacturer and Chuangzhi CloudIt mainly consists of two parts: one is a container containing a discharge body, commonly known as an ozone discharge chamber; The other part is a power supply system that provides high-voltage power to the ozone discharge chamber, commonly referred to as an ozone power supply or power supply unit (PSU). Large ozone generators use water cooling, and the water cooling device should be designed based on the available cooling water conditions on site, including water quantity, water temperature, water quality indicators, etc.

In terms of drinking water treatment, ozone is mainly applied in three ways: ① Ozone is used as a disinfectant for drinking water, and after ozone disinfection, a certain amount of residual chlorine needs to be added at the front end of the pipe network to maintain the stability of the water quality of the pipe network system. ② Ozone is added before the coagulation and sedimentation tank as a pre-treatment for water treatment. Its function is to remove iron oxide and manganese ions, remove color and odor, improve flocculation and filtration effects, replace chlorine addition, and effectively reduce the generation of halogenated hydrocarbon disinfection by-products. ③ In the deep treatment of drinking water, ozone is often combined with granular activated carbon to form the ozone biological activated carbon process. Through multiple processes such as ozone oxidation, activated carbon adsorption, and microbial degradation, the effluent quality is effectively improved. In terms of sewage treatment, the combination of ozone and various technologies has been widely applied, such as ozone ultraviolet, ozone hydrogen peroxide, ozone catalytic oxidation, etc.