1、 Instrument usage instructions

1Instrument composition and accessories

The instrument mainly consists of a collector, a dedicated temperature sensor, and a charger.

2. Preparation before testing

1. Check the battery level of the collector to ensure sufficient power.

2Collector installation: The collector should be installed in a location where the phone signal is good and it will not be affected by rainwaterImmersed place.

3Sensor layout (taking a single collector as an example): Arrange according to the temperature related specifications for large volume concrete.The layout of temperature measurement points is arranged in the order before and after pouringEight temperature measurement points are arranged for different thicknesses of concrete. Temperature measurement points at 3 depths for vertical testing: concrete tableLayer temperature(Temperature at a height of 10cm from the concrete surface), concrete center temperature (i.e. temperature at 1/2 height), and

Temperature at the bottom of concrete(Temperature at a height of 20cm from the bottom of the concrete). For thicknesses less than

The 1000mm measuring point only needs to monitor its internal temperature.

3Power on and off

1Press in shutdown stateTurn on the power button.

2Press and hold while the device is turned onPower button5In seconds, a dialog box pops up and you can choose to shut down.

3Press while the screen is turned offThe 'Power' button restores the display page.

4Main page introduction

6.10 system parameter setting

This parameter is modified by the manufacturer. Please do not enter the modification process as it may affect the operation of the equipment.