H-type imported synchronous beltAnalysis of Damage Causes:

　　

1. Insufficient tension:

　　

If the tension is not sufficient, the friction force will be insufficient, leading to sliding and increasing the wear of the synchronous belt, causing others to lose the ability to transmit loads and rendering the belt transmission ineffective due to unstable transmission.

　　

2. Too nervous:

　　

Excessive tension and deformation of synchronous belts can reduce their service life.

　　

3. There are debris on the synchronous belt;

　　

If there is residual grease or other dirt on the timing belt, due to the presence of chemical substances in the dirt, it will enter the timing belt and damage its material structure.

　　

4. Misalignment of synchronous belt pulley:

　　

If the H-type imported synchronous belt pulley is not centered, the synchronous belt will slip, twist, and experience internal heating and wear, so the synchronous belt pulley must be centered.

　　

5. The length of the synchronous belt varies:

　　

If the length of a row of belts is not equal, the tension of each timing belt will be different, and some may slip or have excessive tension, causing wear on the timing belt. So when using, it is necessary to choose synchronous belts of the same model.

　　

6. If the timing belt does not run for a long time, it needs to be opened, otherwise it will reduce the service life of the timing belt and cause deformation.

　　

7. If the synchronous belt is left for too long, it will cause rubber aging and reduce its lifespan.

　　

8. If there is dust, acidic or alkaline gases or other gases in the environment of the application site, it will cause damage to the synchronous belt and shorten its service life.

　　

9. Excessive vibration amplitude: If the timing belt rapidly twitches due to machine vibration, it will suffer severe sunburn, thereby reducing its service life.

　　

10. Starting overload:

　　

When the timing belt is overloaded, it will generate excessive tension, causing the timing belt to break due to sliding.

　　

11. Wear of synchronous belt pulley groove:

　　

The H-type imported synchronous belt pulley has been in use for too long, resulting in increased wear on the groove edge and incorrect angle. The timing belt may collide with the groove bottom. In order to drive the machine, tension must be increased, causing the V-belt to break.