BSY-100 portable ultrasonic depth meterProduct Introduction

Portable ultrasonic depth sounderIt is a portable depth sounder used to measure water bodies such as reservoirs, lakes, rivers, and shallow seas. During depth measurement, an ultrasonic transducer is placed on the water surface or at a certain position, and the instrument automatically converts the water depth H using the fixed sound velocity VC of ultrasonic waves in water and the time T from ultrasonic transmission to reception..

The instrument can be used for depth measurement in still water or in water with a certain velocity: the water flow velocity can reach about 5 meters per second, making it an ideal depth measurement instrument for hydrological surveys, hydropower plants, storage areas, lakes, river surveys, and environmental water monitoring. Widely used in waterway survey, underwater terrain investigation, underwater positioning, hydrographic (river) survey, ship navigation positioning and hydrological testing, hydropower plants, storage areas, etc.

Features of 100 meter handheld ultrasonic water depth meter

1. Installation outside (inside) of small and medium-sized ships, with a cable length of 10 meters.

2. Mainly used for fixed-point measurement of water depth above and below the sea, river, and lake.

3. Static fixed-point measurement.

4. Self stabilizing measurement technology and fast tracking technology reflect the real measurement results in real time.

5. High precision clock with an annual error of 3PPM.

BSY-100 portable ultrasonic depth meterTechnical Specifications

Range: ≥ 120m

Blind spot: Automatically detect a blind spot of 0.5m (adjustable manually)

Minimum display resolution: 1mm

Working hours: approximately 12 hours

Power: 32 levels of transmission power, automatic gain adjustment

Accuracy: ± 0.5%

Working frequency: 200-2000KHZ

Minimum display resolution

On site setup: completed through sensor buttons

Power: 200-2000KHZ

Display: Chinese LCD

Calibration: Factory calibration, can be calibrated on-site

Host: ABS Engineering Plastic Sensor: Copper or Stainless Steel

Working voltage: built-in battery, external charger

Keyboard: numeric keypad

Material: Host: ABS Engineering Plastic Sensor: Copper or Stainless Steel

Sensor cable: wire diameter 5-10mmx10m

Working humidity:<80% RH, no condensation

Working temperature: -40 ℃~70 ℃

Detection method: 15Hz/s

portable ultrasonic water depth sensorMaintenance of instruments

The maintenance of the depth gauge must be disconnected and stored when not in use for a short period of time. When not in use for a long time, it needs to be charged once every three months.

Portable ultrasonic depth sounderSpecial Reminder:

The testing time should be greater than 20 seconds, and the instrument should be charged for more than 3 hours. Please use up the battery before charging each time The sensor must enter the water vertically, and if it enters the bottom of the river irregularly or with a lot of debris, it may affect the air quality. Measurement accuracy, multiple measurement points can be measured.