Do you know that the constant temperature and humidity test chamber also has a break in period

Actually, any brand new device will have a transitional period of running in when it first starts to be used, of courseHumidity ChamberIts use also has a break in period, which is an important period for testing the performance of the testing equipment, the operation status of the equipment, and the ability of the staff to control the equipment. The break in of the equipment is mainly reflected in two aspects:

The running in between equipment accessories: The new testing equipment uses brand new components and accessories, and the contact between each accessory during use will cause certain running in. The load-bearing and compressive capacity of each component is weaker compared to the accessories that have been used for a period of time. Therefore, overloading should be avoided during equipment operation and strictly controlled within the allowable range.

The running in between operators and testing equipment: Due to the fact that the operators have just come into contact with the constant temperature and humidity test chamber, they may not be familiar with the operation of the equipment, so the early work efficiency and accuracy may not be as good. Through slow running in during the use of the equipment, it is believed that the work efficiency will quickly improve. At the same time, with the accumulation of experience during the running in period, the operators will also quickly solve some equipment problems and faults in the future.

During the running in period, the staff should pay attention to the maintenance of the constant temperature and humidity test chamber, regularly check the operation of various components of the equipment, and if any abnormal situations are found, they need to be repaired and dealt with in a timely manner. Usually, before using the test equipment, the manufacturer will provide knowledge training to the operators. Through relevant training, the staff have a simple understanding of the structure, operation, performance, common problems, etc. of the test equipment. However, there are still many influencing factors and instability when new equipment is running in, so the operators still need to go through a certain running in period in order to have a deeper understanding of the equipment and master the equipment operation skills proficiently. Whether it is for equipment accessories or between equipment and operators, the running in period is a process of mutual adaptation, so there is no need to worry, just treat it with a calm mind. Okay, that's it.