DIN 1X1 ISO U(A)-P-D-L 系列Programmable Analog to PWM Power Control Isolation AmplifierIt can isolate and convert analog signals such as 4-20mA/0-20mA/0-5V/0-10V output from sensors, instruments, and transmitters into PWM pulse width modulation power amplification control signals, and achieve PWM frequency programmable output. The product is embedded with an MCU microcontroller for AD input conversion control, and the output control design is divided into MOS transistor drain open type (OD gate) passive PWM high current control output method DIN 1X1 ISO U (A) - P-D-L1 series and active PWM voltage pulse width control output method DIN 1X1 ISO U (A) - P-D-L2 series.

Product Features

01. Analog signal to high-power PWM control with sensitive resolution and fast response speed

02. Linearity over the full range (nonlinearity<0.5%)

03. Two PWM output modes: MOS transistor open drain type and voltage pulse output type

04. Auxiliary power supply and signal input/output 3000VDC triple isolation

05. Auxiliary power supply: Single power supply with a wide voltage range of 10V~24VDC

06. Low cost and ultra small size, standard DIN35 rail installation

07. Strong resistance to EMC electromagnetic interference and high-frequency signal spatial interference characteristics

08. Industrial grade temperature range: -40~+85 ℃