DNA6000 series vector network analyzer

DNA6000 series vector network analyzerProvides multiple calibration methods such as frequency response, single port, response isolation, enhanced response, full dual port, and electrical calibration. It has multiple display formats including logarithmic amplitude, linear amplitude, standing wave, phase, group delay, Smith chart, polar coordinates, etc. It is also equipped with multiple standard interfaces such as USB, LAN, HDMI, etc. It can accurately measure the amplitude frequency characteristics, phase frequency characteristics, and group delay characteristics of microwave networks.

DNA6000 series vector network analyzerRetaining the characteristics of the product, including performance indicators, instrument appearance, display effect, and software interface, while controlling the volume, weight, and wind noise of the instrument, to create a good user experience. This product can be widely used in fields such as electronics, communication, and microwave, and is a commonly used testing equipment in industrial and university research and mass production processes.

The technical specifications are applicable to the following conditions: the instrument is within the calibration cycle, stored at a temperature of 0 ℃ to 50 ℃ for at least two hours, and preheated for 60 minutes. The data in this manual, unless otherwise specified, are technical indicators that include measurement uncertainty.

• Typical value: Refers to the typical performance that can be achieved by 80% of the test results at room temperature (approximately 25 ℃). This data is not guaranteed and does not include measurement uncertainty.

• Nominal value: represents the expected average performance or design performance characteristics, such as a 50 Ω connector. This data is not guaranteed and was measured at room temperature (approximately 25 ℃).

• Measurement value: represents the performance characteristics measured during the design phase, which can be compared with expected performance, such as amplitude drift over time. This data is not guaranteed and was measured at room temperature (approximately 25 ℃).

Specification value: indicates guaranteed performance. The specifications include limitations, and all specifications and characteristics are applicable within the room temperature (approximately 25 ℃) range (unless otherwise specified).

DNA6000 series vector network analyzerFeatures:

• Frequency range: 5 kHz~26.5 GHz

•Number of ports: 2/4 ports

•Frequency resolution: 1 Hz

•Maximum output power: 10 dBm

•High dynamic range: 127 dB (typ.)

•Trace noise: 0.003 dB rms

•Intermediate frequency bandwidth range: 1 Hz to 10 MHz

•Compatible with mechanical and Ecal electronic calibration components, supporting multiple calibration types (SOLT, Response Short, Response Open, OSL, etc.)Enhanced Response 1 to 2、Response Thru）

•Integrating functions such as S-parameters, impedance, standing wave, TDR time-domain analysis, fixture embedding/deintercalation, antenna testing, etc

•Volume (358.1 mm × 214.8 mm × 300 mm)

•10.1-inch 1280 * 800 high-definition touch screen display

•Supports LAN, USB Device, USB Host, GPIB communication interfaces

•Support standard SCPI commands

•Supports multiple interfaces such as USB, LAN, HDMI, etc., facilitating system integration and data export.

•Support Web Control remote operation

•Supports dual operation modes of touch screen and physical buttons, and supports keyboard/mouse input