Electric high-speed tissue crushing homogenizer

JJ-2（B）User Manual for High Speed Organization Crusher

1sketch:

Organizational crusherThe shell is made of aluminum alloy casting, and the crushing cup and blade are stamped with stainless steel plate, with adjustable speed and a timing device.

IITechnical Specifications:

Power supply voltage: 220V 50HZ

Adjustable speed range: 12000 revolutions per minute

Motor power: 200W

Capacity: 1000ml, converted to 100g solid, 800ml liquid

IIIUsage:

Firstly, lift the coupling joint between the motor and the crushing rod upwards so that the crushing rod can be removed. Take out the crushing cup and add the desired substance and solution to the crushing cup. Install the cup and rod as they are (with the lower end of the rod aligned with the axis) and cover the cup tightly. Check the timer knob and turn it to the ON (normally open) position or the time position you specify. Turn the speed control knob counterclockwise to the lowest position, turn on the power supply, turn on the power switch, the indicator light will be on, and then turn the speed control knob clockwise to the speed you need for mixing the homogenate. Medium and low speeds are sufficient. When crushing plants, choose high speed. If there is noise during high-speed crushing, replace the solution. At this time, the power should be cut off and the above operation should be repeated.

4Notes:

This machine adopts a three eye safety socket. Before use, the ground wire must be connected properly. When working, the machine should be placed on a flat and solid table to prevent vibration. When crushing at high speed, the cup cover should be held down by hand. When it is difficult to slide the connecting shaft up and down, one to two drops of engine oil should be injected to lubricate it. It is forbidden to crush hard materials such as bones and minerals. This machine uses a series motor, and its carbon brush is generally used for about 500 hours. It should be replaced in a timely manner to avoid the phenomenon of the commutator being worn out due to the polishing of the carbon brush. After the machine is completed, the crushing cup should be cleaned and inverted before installation, and placed in a dry and ventilated place.