Integrated temperature vibration sensor

Manual for Temperature Vibration Transmitter

1） Overview:

Mic -umThe integrated temperature vibration transmitter is a micro transmitter independently developed by our company, mainly composed of piezoelectric sensitive elements and main circuits such as measurement, conversion, integration, amplification, and transmission.On the basis of the original piezoelectric accelerometer, it has added a built-in precision integration circuit to achieve the output of velocity, which has the characteristics of excellent dynamic characteristics, wide frequency response, long service life, and small yet exquisite appearance. This product has excellent characteristics such as wiring fault tolerance protection, good stability, and strong anti-interference ability. The temperature adopts Class A PT100 chip with high precision.

2） Main technical parameters:

Measurement range: Temperature 0-200 degrees

Vibration speed 0-100mm/s

Vibration acceleration 0-18g

Vibration displacement 0-2000um

1. Output mode: Two channel 4-20mA four wire system (see lead terminal identification for details)

2. Response frequency: 2Hz-2000HZ (acceleration)

5Hz-2000HZ(Speed measurement)

10Hz-2000HZ(Vibration displacement)

3. Speed direction: from bottom to sensor (forward)

4. Environmental temperature: -40 ℃~+85℃

5. Accuracy: ± 5%

6. Supply voltage:+24VDC

7. Maximum impact capacity: 2000g

8. Piezoelectric material: PZT-5

9. Protection level: Ip65

10. Weight: Approximately 110g

11. Shell material: aviation aluminum or stainless steel

12. Explosion proof grade: EX ia IIB T4 Ga

Note: This product is a 4-wire two-way 4-20mA system. Please carefully check the factory label

3） Selection Table

Mic -umSelection of piezoelectric integrated temperature vibration transmitter

MIC-ZD- □-C□□-D□□-E□□-F□□-T

example:MIC-ZD-B -C（V02）-D（11）-E（01）-F(4)-T

Indicating: Measurement type---Non explosion proof speed measurement, range---0 -20mm/sInstallation method----M8 × 1.25Cable length1Mi,4-20mA,temperature0-200Degree, corresponding output4-20mA.

8） . Installation

8Installation position: Install on the measured vibration point, fix the bottom of the transmitter on the measured housing, and then tighten the transmitter on top.

8．2 Wiring instructions:

Four wire wiring: red wire - vibration DC24V positive; Green Line - Vibration 4-20mA

Yellow line - Temperature DC24V positive; Black line - Temperature 4-20mA