Micro differential pressure transmitter - Shanghai Yichuan Instrument

Micro differential pressure transmitterUsage description:

Differential pressure transmitters are mainly used to measure the differential pressure, pressure, liquid level, and density of liquids, gases, or vapors, and then convert them into 4-20mA.DC signal outputs.
Differential pressure transmitters include three types: DP type (base type), HP type (high static pressure), and DR type (micro differential pressure). The above three types of transmitters can be combined with an intelligent amplifier board to form an intelligent differential pressure transmitter, which can communicate with each other through a handheld device that complies with the HART protocol for setting and monitoring.
The HP type high static pressure differential pressure transmitter is a type of differential pressure transmitter suitable for high-pressure equipment in petrochemical and power plants. Due to its high pressure resistance of up to 32MPa and the ability to withstand unidirectional overload pressure without damage, it can be reliably used for differential pressure measurement in high-pressure systems.
The DR type differential pressure transmitter can convert small differential pressures into 4-20mA DC signals. It uses a specially designed amplification circuit board and a special temperature compensation process, ensuring stable and reliable performance. It is an ideal product for detecting micro pressure, primary and secondary air flow, and airflow loss in furnace combustion chambers.

LED-1151 series code

Micro differential pressure transmitterThe selection code

Measurement type

DR

High static pressure differential pressure transmitter

2

0 -0.125～1.5

Output signal type

F

4-20mA.DC analog amplifier, linear output

S

4-20mA.DC intelligent amplifier, using HART protocol communication

Liquid receiving material

Container and connector

Exhaust/Drain Valve

Isolation membrane

12

carbon steel

316 steel

316 steel

22

316 steel

316 steel

316 steel

Type of filling fluid

none B

silicone oil

Allowable static pressure value

A

2

B

5

display mode

M1

Linear indicator with 0-100% scale

M2

Square root indicator scale 0-10

M4

Digital display indicator with 0-100% scale

Bracket form

B1

Pipe installation bending bracket (installing pipe diameter 60)

B2

Board mounted bending bracket

B3

Pipe installation bending bracket (installing pipe diameter 60)

Location of exhaust/drain valve

D1

The exhaust/drain valve is installed on the upper part of the side of the chamber

D2

The exhaust/drain valve is installed at the lower part of the side of the chamber

flameproof type

d

Explosion proof type, explosion-proof mark Exd Ⅱ BT4-6

LED-1151

DR

2

F

12

A

M1

B2

Example of Selection for 0-0.4KPa