No quotation - Testing Pan American Ultrasound Pulse 444

Ultrasonic pulse transmitter receiver/Olympus pulse transceiver/Ultrasonic pulse transmission and reception detectorOlympus model 5073PRManually controlling the ultrasonic pulse generator receiver can be used for both conventional and high-frequency applications. In applications that require high axial and near surface resolution, this device75 MHz（-3 dB）The bandwidth and rapidly rising sharp pulse generator can improve50 MHzThe working performance of the probe.

Pan American ultrasonic pulse transmitter receiver/Olympus pulse transceiver/Ultrasonic pulse transmission and reception detectorOlympus model 5073PRIt has broadband negative spike excitation pulses and material penetration performance suitable for manual control and computer-based detection systems, thereby improving the performance of automatic detection.Olympus PanametricsThe pulse generator-The receiver can be used in conjunction with computer-based systems to complete automatic ultrasonic testing applications that require high material penetration performance and extremely low noise amplification of ultrasonic signals.

Pan American ultrasonic pulse transmitter receiver/Olympus pulse transceiver/Ultrasonic pulse transmission and reception detectorOlympus model 5073PRHigh performance broadband（75MHz）Negative peak excitation pulse generator, peak excitation pulse generator can optimize broadband response and near surface resolution; Damping, pulse energy, and repetition rate are optional;

Pan American ultrasonic pulse transmitter receiver/Olympus pulse transceiver/Ultrasonic pulse transmission and reception detectorOlympus model 5073PRTechnical specification introduction:

optional20MHzLow pass filter;

Optional high pass filter for fast recovery time and low-frequency noise suppression;

Compatible with Pan American's stepless gates, gate peak detectors, gate threshold alarms, and automatic systems;
Pulse generator: pulse repetition rate0.2~10kHzAdjustable;

*Large pulse amplitude:-180V（100ΩDamping, fourth gear energy position, no external load);

Damping range (pulse echo mode or penetration mode):12/14/17/20/25/33/50or100ΩOptional;

Pulse rise time（50ΩDamping, * small energy):<2ns（10%-90%）；

Pulse energy（CE2/2）：2、4、8and16Micro focus (optional);

Synchronization signal output:3.5V(Damping)= 50 Ω）, in2.4VUp can drive26A standardTTLLoad;

External triggering requirements:+2.4V(* Large7V）（1000pfand10kΩSeries connection), * small pulse width200ns；
Receiver input impedance (penetration mode):100Ω(Linear range), when the signal is greater than the linear range, it is approximately100Ω；

*High input power: * High average power400mW；

Phase: Reverse phase or non reverse phase (built-in selector switch);

Attenuator:0~49dB，1dBStepping;

Voltage gain (bandwidth)35MHzDamping= 50 Ω）：0~39dB，1dBStepping;

Output noise: typical7mVp-p(Bandwidth)75MHz）；

High pass filter:1kHz（out）Or5MHz(Select);

Low pass filter:75MHz(* Large) or20MHz(Select);

Insulation between pulse generator and receiver: in50MHzTime * small53dB(Typical)62dB）；

*Large output voltage fluctuation:±1.0Vpk(Damping)= 50 Ω）；

Output impedance:50Ω；
Power requirements:100/120/220/240VAC，50~60Hz，7.5W；

Fuse:1/4A（100/120VAC），1/8A（220/240VAC）；

Size:178x89x232mm；

Weight:2.3kg；

Operating Temperature0~50℃；