RLS-80 Plastic Dehumidifier (Three in One Dehumidification and Drying Machine)

The three machine integrated dehumidification dryer produced by Ruilang Company is widely used in the plastic processing industry. In the plastic processing process, engineering plastic materials such as PA, PC, PET, PETG, ABS with strong moisture absorption have been proven to be greatly affected by their surrounding environmental conditions, and traditional hot air drying systems cannot effectively reduce their moisture content

The three machine integrated dehumidification dryer produced by Ruilang Company is widely used in the plastic processing industry. In the plastic processing process, engineering plastic materials such as PA, PC, PET, PETG, ABS with strong moisture absorption have been proven to be greatly affected by their surrounding environmental conditions, and traditional hot air drying systems cannot effectively reduce their moisture content. These highly hygroscopic engineering plastics must be dried with stable and high low dew point air (at least -32 ℃) and appropriate drying temperature before molding to ensure that the final moisture content is reduced to below 0.02%. Once this condition is met, these plastic molded products can exhibit their optimal physical properties and surface luminosity. An efficient dehumidifier dryer, due to its closed circulation system and low dew point drying air that can be lowered to below -50 ℃, can quickly release moisture to the drying air, and can help molding operators avoid shrinkage, silver lines, or dents in the molding process.

　　

Characteristics of Ruilang three machine integrated dehumidification dryer:

　　

1. The adsorption area of molecular sieves with a large adsorption area per gram can reach 700 square meters/KG; the honeycomb wheel can spread out up to 6000 cubic meters per cubic meter; Achieve maximum adsorption area and minimize the size of the dehumidifier;

　　

2. The honeycomb shaped center with low energy and high efficiency has a thickness of 0.22mm, making it very fast when absorbing moisture and regenerating rubber when wet. The regeneration temperature is 160 degrees Celsius, which is more than 40% less energy than the traditional regeneration temperature of 230 degrees Celsius.

　　

3. The ultra-low dew point performance stable dehumidification rotary dehumidifier is formed by two-stage crystal growth, and uses dry air as the dehumidification medium. Therefore, a single rotary can achieve a dew point of -80 degrees, which is currently the only one among all factories in the world and has won the Japan National Top 10 Excellence Award. Moreover, under unchanged air inlet conditions, the humidity change on the dry side is within ± 0.5 ℃ of the dew point.

　　

4. Long lifespan, washable wheel substrate is made of inorganic ceramic fibers, which are acid, alkali, and corrosion-resistant, and can withstand temperatures up to 1000 ℃ for fire prevention. Because the adsorbent is formed into long crystals, it can be cleaned with water or solvents without reducing its performance. The average lifespan is over 10 years.

　　

5. The safe quality control dehumidification wheel not only undergoes performance, tension, and pressure tests on six surfaces, but also undergoes a 2000MM air pressure test for airtightness. All parts undergo strict quality control, and the test dew of each dryer before leaving the factory must be below -45 ℃ to ensure the quality of future operation.

　　

6. No special cooling operation is required for maintenance, and it is easy to achieve at a dew point of -40 ℃ without using frozen ice water. It can be easily achieved by using general moist cooling water. Except for the windmill, only the speed regulating motor is the power component, so there are few faults and easy operation and maintenance.