Stress relieving operation mode of fully automatic vibration aging instrument

Stress relieving operation mode of fully automatic vibration aging instrument

Timed fully automatic operation mode (recommended to use this operation method)

1power on

Refer to Figure 2, connect the controller1(Main power switch) press direction“I”At this position, the power supply of the entire device is turned on. At this time, the LCD screen on the front panel will light up and cycle to display the company introduction and simple usage instructions. At the same time, the green power indicator light on the printer will light up.

2Scheduled fully automatic operation

After turning on the device, refer to Figure 1 and first press3（Manual deceleration button）The key, then1The liquid crystal screen displays the time setting screen, and every time it is pressed2（Manual speed up button）Press the key to increase the time display5Minutes, until40Return later0Let's start over. After setting the desired time limit, press4（run/Stop buttonWhen the device enters the timed automatic operation process(Search for sub resonance points and enter the aging state after pre vibration scanning) TimeAfter the set time, it will automatically enter the post vibration scanning and then stop. The entire scanning and aging process will be automatically completed by the equipment according to the optimal process.

3After the device completes automatic operation and stops, press5(Print key) can be used toa—nThea—tPrint out the curves and data for long-term preservation.Stress relieving operation mode of fully automatic vibration aging instrument

Operation precautions:1Peak points appear during the scanning process

2The acceleration at the peak point should exceed60 m/s²

3When the acceleration value at the peak point exceeds160m/s² At this time, the device will automatically protect itself