Temperature and humidity comprehensive vibration test chamber

The temperature and humidity comprehensive vibration test box produced by Aisili Company is widely used in colleges and universities, aerospace, electrical engineering, electronics, medical, military, shipbuilding, automotive and motorcycle fields. Over the years, the product quality has been stable, the supply is timely, and the service is thoughtful and has been fully recognized. In the future, we will continue to provide you with the equipment and services we offer.

　　A brief introduction to the temperature and humidity comprehensive vibration test chamber

The temperature and humidity comprehensive vibration test box produced by Aisili Company is widely used in colleges and universities, aerospace, electrical engineering, electronics, medical, military, shipbuilding, automotive and motorcycle fields. Over the years, the product quality has been stable, the supply is timely, and the service is thoughtful and has been fully recognized. In the future, we will continue to provide you with the equipment and services we offer.

Detailed introduction of vibration, temperature and humidity comprehensive test chamber

Vibration, temperature and humidity comprehensive test chamber

1Temperature and humidity three comprehensive vibration test box Product purpose:

The temperature and humidity vibration test chamber is suitable for testing various performance indicators of aerospace products, information electronic instruments, materials, electricians, electronic products, and various electronic components under temperature, humidity, vibration, and environmental conditions.

IITechnical parameters of temperature and humidity comprehensive vibration test box:

Temperature range: -20 ℃~150 ℃ -40 ℃~150 ℃ -60 ℃~150 ℃

Temperature uniformity: ≤± 2 ℃

Temperature fluctuation: ± 0.5 ℃

Temperature deviation: ≤± 2 ℃

Heating and cooling rate: 0.7 ℃~1.0 ℃/min

Time setting range: 0-9999 hours

Sine wave: 2.94kN (300kg)

Frequency range: 5-500Hz

High acceleration: 980m/s2 (100g)

High speed: 1.1m/s

Large displacement: 25mmp-p

Effective mass of moving parts: 2.7kg

Large load: 120kg

Table size: 150mm x 150mm

Vibration direction: vertical up and down

Power requirements: AC380 (± 10%) V/50HZ three-phase five wire system

IIIStructural characteristics of temperature and humidity comprehensive vibration test box:

Main body: The outer shell of the temperature and humidity vibration test chamber is made of A3 steel plate and has undergone spray coating treatment. The inner liner is made of SUS stainless steel mirror panel and the insulation medium is ultra-fine glass wool.

Circulation mode: Partial centrifugal fan blades supply air, bottom return air.

A double-layer high-temperature resistant high tensile sealing strip is used between the door and the box to ensure the sealing of the testing area.

Using non reactive door handles makes operation easier.

The observation window is made of multi-layer insulated tempered glass, with a laminated conductive film on the inside (allowing for clear observation of the test process)

The lead hole (on the left side of the machine) can be used for external testing of power or signal wires (diameter 50mm).

There is a guide rail below the studio that can be used to move the vibration table body in and out (when not conducting vibration tests)

The connection and sealing between the vibration table and the lower part of the working room adopts a multi-layer epoxy resin and high-temperature resistant silicone rubber alternating plug-in connection (for sealing).

The heating system uses a finned stainless steel heater with a far-infrared nickel complex gold wire heating core.

The two systems are independently controlled and do not interfere with each other.

Supply air circulation system Xiangming motor (low noise), multi wing centrifugal wind turbine, single cycle.

5Compliant with standards:

The temperature and humidity vibration test chamber complies with GB/T2423.1-2001, GB/T2423.2-2001, GB/T2423.3-93, GB/2423.10-99, JJG190-97