Wanke WAGO module 750-550 signal type

Wanke WAGO module 750-550 signal type

This analog output module can receive 0-10V standard signals.

The output signal is electrically isolated and transmitted in the form of a 12 bit resolution.

The output end has a short-circuit protection function.

The internal power supply system provides power to this module.

The output channel has a common ground potential.

Analog output quantity 2

Total number of channels (modules) 2

Signal type voltage

Voltage signal type 0... 10 VDC

2 x (2-wire) actuator connections

Resolution (bits) 12Bit

Data width 2 x 16 bits; 2 x 8-bit control/status (optional)

Load impedance (voltage output) ≥ 5 k Ω

Conversion time (typical) 2ms

Measurement error (reference temperature) 25 ° C

Measurement error - deviation relative to the upper limit value () 0.1%

Temperature error relative to the upper limit value () 0.01%/K

Output error, reference temperature

Output error, deviation relative to the upper limit value () 0.1%

Temperature error of output range value () 0.01%/K

Recovery time (typical) 0.3ms

Linearity ± 10 mV

Supply voltage (system) 5 VDC; Through data touchpoints

Power consumption (5 V system power supply) 65mA

Isolation of 500 V system/on-site

指示灯 LED (A, C) green: Function AO 1, AO 2

Wanke WAGO module 750-550 signal type