DFS crushing grid cleaning machine for sewage treatment plant

NegotiableUpdate on 07/31

Model

Nature of the Manufacturer: Producers

Product Category

Place of Origin

Online Consult

Overview

Brief description: If the blockage still exists in the DFS crushing type grid cleaning machine of the sewage treatment plant, the controller automatically executes the reverse process within 30 seconds, which can be executed three times. If the blockage still exists after three reversals, the controller will cut off the power supply to the motor and activate the delay and abnormal status indicator lights.

Product Details

brand	Lino	Target audience	other

DFS crushing grid cleaning machine for sewage treatment plant

Performance testing:

1. The protective cover, driving mechanism, and the entire mechanical grille should be assembled and tested in the factory to verify that the grille machine meets the performance requirements and relevant standards specified in the design.

2. Before shipment, the bidder shall conduct a comprehensive inspection of the quality, specifications, performance, quantity, etc. of the goods, and issue a certificate proving that the goods comply with the contract requirements.

3. On site performance testing project

Check the external dimensions and appearance quality.

When the noise equipment is running, its noise value should not exceed 76db (A).

Whether the electrical control function meets the requirements, the wiring should be correct, the wiring should be neat, and there should be no safety factors.

The mechanical overload protection device is sensitive and reliable. When overloaded, it sends an alarm signal and the equipment stops working.

Verify operational accuracy. The whole machine should run smoothly and continuously for 48 hours during the trial operation. When the cleaning machine is working, the entire machine runs smoothly without any jamming, scratching, or abnormal phenomena, and the mechanism operates flexibly and reliably.

DFS crushing grid cleaning machine for sewage treatment plant

Daily maintenance:

1. Weekly inspection

1) Check whether the electrical circuit and emergency stop function of the equipment are normal;

2) Check if the equipment is running smoothly and if there are any abnormal noises.

2. Daily check

1) Add calcium grease to the bearing seat once with an oil gun;

2) Check if the entire machine is running in balance and if there are any abnormal noises;

3) Check if there are any foreign objects entangled, and if so, remove them immediately;

3. The lubricating oil (No. 30 mechanical oil) in the reducer needs to be replaced regularly. Generally, when the equipment is put into normal use, it needs to be replaced with new oil after half a month of operation. Afterwards, the oil should be replaced every three months, and the reducer oil level should be paid attention to during normal operation.

4. This machine should avoid long-term "shutdown". If the equipment is not immediately put into operation after installation, it should be idle for at least one hour per week and checked whether all parts of the equipment are in good condition.

Electrical control:

Conventional is manual control; Can be equipped with PLC interface; Fully automatic control is possible.

Product advantages:

Motor: IP68 amphibious motor, capable of working continuously in the air for 24 hours.

Cable: The length can be adjusted according to actual working conditions. It is a seven core cable with leak protection and overload protection signal lines.

Shell: Carbon steel or stainless steel structural components, subjected to high temperature solution treatment at 1500 ℃ for stable and firm structure

Blade: Made of high-strength alloy steel material, with a hardness of up to 65 and wear-resistant

Shaft: Made of high-strength alloy steel material, high temperature modulation, sturdy, wear-resistant