Non contact five wheel instrument

NegotiableUpdate on 01/07

Model

Nature of the Manufacturer: Producers

Product Category

Place of Origin

Online Consult

Overview

The non-contact five wheel instrument is developed and researched according to the national mandatory standard GB7258-2017 "Technical Conditions for Safety of Motor Vehicle Operation". It is suitable for the requirements of GB38900-2020 "Motor Vehicle Safety Inspection Items and Methods" and GB18565-2016 "Comprehensive Performance Requirements and Inspection Methods for Operating Vehicles" and is applicable to motor vehicle safety performance testing stations. It can be used as a portable brake performance tester for dynamic detection and a testing device for vehicle driving recorders.

Product Details

Product Introduction:

Non contact five wheel instrumentIt is developed and researched based on the national mandatory standard GB7258-2017 "Technical Conditions for Motor Vehicle Operation Safety", and is applicable to the requirements of GB38900-2020 "Motor Vehicle Safety Inspection Items and Methods" and GB18565-2016 "Comprehensive Performance Requirements and Inspection Methods for Operating Vehicles". It is suitable for motor vehicle safety performance testing stations and can be used as a portable brake performance tester for dynamic testing and a testing device for vehicle driving recorders.

This instrument adopts imported GPS sensors and high-speed signal acquisition system, with a large screen dot matrix LCD display, Chinese operation menu, miniature Chinese character printer, and standard RS232 networking interface.

Non contact five wheel instrumentTest project:

Vehicle speed test, road test, positioning test, braking test, acceleration test.

Performance parameters:

Built in power supply: DC12V

External power supply: DC12V

Instrument interface: Standard 9-pin RS232 interface, baud rate 9600, data bits 8, stop bit 1, no verification.

Operating temperature: -20-40 ℃

Environmental humidity: 30-80%

serial number	item eye	measure quantity Fan enclose	accuracy
1	speed	0～300.000 km/h	±1%
2	distance	0～99999.999 m	±1%
3	time	0～9999.999 s	±0.1%
4	longitude	0～180.00000°	±2%
5	latitude	0～90.00000°	±2%
6	altitude	-999.9～999.9 m	±2%
7	MFDD	0～9.99 m/s2	±2%
8	Maximum deceleration	0～9.99 m/s2	±2%
9	average deceleration	0～9.99 m/s2	±2%
10	Average acceleration	0～9.99 m/s2	±2%
km/h: Kilometers/hourm: Metermm: Millimeterss:secondms:millisecond

Notes:

1. This instrument is a precision instrument. Please handle it gently and avoid severe vibration during use.

During use, avoid prolonged exposure to strong light on the LCD screen to prevent it from aging.

3. When plugging in sensors, be careful to avoid connecting them incorrectly and burning out the instrument and sensors. The photoelectric sensor is a valuable sensor, please pay special attention to it.

4. After turning on the power switch, if the power indicator light does not light up and there is no display on the screen, please check if the fuse is intact. If necessary, please replace the fuse (2A) with the same specification.

When the power indicator light goes out, it means that the internal battery is running low and needs to be charged. Please use the dedicated charger provided with the instrument for charging operation, which usually takes 10 hours.

The internal battery equipped with the instrument is only for short-term experiments or demonstrations. If conducting long-term experiments, an external power source should be used.

During the testing process, if there is no response to the buttons or no change in the screen display, please press the "Reset" button to restart the instrument. Or turn off the power switch, and after a while, turn it back on for testing.