Separate temperature controlled water bath pots

Separate temperature controlled water bath potsAdopting authentic304Series stainless steel production, mold stamping, curved corners, no welding, gas synthesis, surface coated with epoxy powder electrostatic spraying, with * anti rust ability, can be used for constant temperature heating in water bath and other temperature tests.

Separate temperature controlled water bath potsProduct Features:

1The studio is made of high-quality stainless steel plates, with rounded corners, smooth, fluent, and easy to clean.

2Using steel and brass pipes as heat sensing elements, installed under the partition of the box, directly immersed in water for fast heat transfer and high sensitivity.

3Electric heating tubeUSteel pipe, made of sintered magnesium oxide and electric heating wire, with less heat loss when directly immersed in water.

4The temperature control is manufactured using microcomputer intelligent digital technology and has industrial capabilitiesPIDSelf tuning andLEDWindow indicator function, control5High temperature accuracy and resistance.

6The lid is a sleeve that can be used for measuring cups of different sizes.

7The water outlet pipe is a concealed extension type, which is easy to use, durable, and aesthetically pleasing.

Separate temperature controlled water bath potsMain technical parameters:

1Power supply; 220V50HZ

2Temperature control range:room temperature~100℃

3Heating power; 300W×2/3/4Kong

4Temperature resolution: ±0.1℃

5Temperature control accuracy: ±0.5℃

6Working size: (160×160×140mm)×2/3/4Kong

Usage and precautions:

1Safe use of electricity:This product is used for220VAC power supply, power sockets should use three hole safety sockets and must be properly grounded. The ground wire must not be connected to the gas pipe.

2Inject an appropriate amount of clean tap water or ordinary distilled water into the studio. Before powering on, the water should be injected into the pot above the partition and placed in a container. During use, the heating tube must not be exposed to the water surface, otherwise the heating tube will burn or even burst, or the solder will melt and leak water, or cause electric shock.

3If necessary100℃When using boiling water distillation, do not add too much water to prevent overflow during boiling.

4Connect the power, turn on the temperature control switch, and the monitor will start from99.9Evolved to the actual temperature inside the instrument container, according to“SET”Press the key to make the digital display to the right of the decimal point blink. At this time, set the desired preset temperature. Press ▲ to increase the number, and press ▼ to decrease the number. Press again“SET”The key displays the actual temperature inside the instrument container. If the temperature inside the instrument container is significantly different from the displayed temperature, make the following adjustments: long press“SET”Key, when displayed as“E 1.5”Release it（E 1.5For advance quantity control, it has been adjusted before leaving the factory, please do not adjust it yourself), and then press“SET”Press the key to display a number (without any English letters at this time), press ▲ to increase the temperature, and press ▼ to decrease the temperature (for example, if the actual temperature inside the instrument container is greater than the displayed temperature, then the deviation between ▲ and ▲ is required), and continue calibration. Press again“SET”Key, displayed as“P 2.0”（P 2.0For the proportional band, it has been adjusted before leaving the factory, please do not adjust it yourself. Press again“SET”Display the temperature inside the instrument container. “OUT”The light on indicates that the preset temperature is higher than the temperature inside the instrument and is in a heating state.(The temperature needs to be kept at a constant temperature to maintain the correct error)

5Do not use heaters in a water bath without water.

6If the water bath is not used for a long time, the water in the water bath should be drained, wiped clean with a soft cloth, and dried.

7After use, cut off the power and clean the dirt inside the pot, Easy to use next time and extend the lifespan of the machine.