UHZ electric remote transmission magnetic flap level gauge

Electric remote transmission magnetic flap level gaugeIt is another type developed for centralized control in response to demandSide installation/Top mounted (bottom mounted) products have the advantages of clear on-site indication and remote control This product can be widely used for liquid level indication on various towers, tanks, tanks, and spherical containers in industries such as petrochemicals, fertilizers, pharmaceuticals, ships, and military.

Electric remote transmission magnetic flap level gaugeMain technical indicators:
technical requirement
Measurement range: 0-5000mm
Accuracy: ± 10mm ± 16mm
Flip column diameter: 10mm, 16mm
Nominal pressure: 2.5MPa
Medium density: ≥ 0.7g/cm3 (special requirements can reach 0.45g/cm3)
Medium temperature: -20 to+350 ℃
Wetting Material: Stainless Steel 304/316/316L and PP Material
Medium viscosity: ≤ 2.0Pa.s
Environmental vibration: frequency ≤ 25Hz, amplitude ≤ 0.5mm
Follow speed: ≤ 0.05m/s
Flange standard: HG20592-20635-97
Alarm and remote transmission device: The technical parameters are the same as those of the UHZ-25 series.



Electric remote transmission magnetic flap level gaugeSelection instructions:
1. The nominal pressure of anti-corrosion type is ≤ 1.0MPa.
2. There is a certain blind spot in the liquid level gauge, so compensation for the blind spot value should be added when reading the liquid level height (when our liquid level gauge leaves the factory, the zero position of the scale has been moved to the actual value).
3. The measuring range of the liquid level gauge should not exceed 5 meters, otherwise it will affect the stability, reliability, and fastness of the liquid level gauge.
4. Install the connecting flange, and refer to the commonly used protrusion size reference (HG21592-97) for manufacturing this level gauge at the factory.

Electric remote transmission magnetic flap level gaugeInstallation, use, and maintenance:
1. The protective conduit and main conduit of the liquid level gauge must be kept vertical
2. The connecting rod cannot bend and must be inserted straight
3. After installation, the flip column of the monitor needs to be guided once with magnetic steel to display white above zero and red below zero.