ULZC type heavy hammer level gauge

ULZC type heavy hammer level gaugeThe heavy hammer level gauge can be used to measure the level of solid materials in powder, granular, and block material silos. The heavy hammer level gauge is composed of sensors and control display instruments, and the entire detection process of the sensors is controlled by a program. It absorbs the advantages of similar products at home and abroad, has reliable operation, low maintenance, and wide application.

The heavy hammer level gauge can measure feed, chemicals, plastic pellets, cement, stones, PVC powder, aggregates, liquids, coal, limestone, ground plastics, sand, powder, grains, oil, etc. Heavy hammer level gauges are commonly used in power plant ash silos, coal bunkers, slag silos, mud pits, etc. Advantages: Mechanical measurement, simple and reliable, strong anti dust interference ability. The range of the heavy hammer level gauge can reach up to 45.7 meters. The heavy hammer level gauge has multiple dust-proof designs (dust-proof brush, air inlet, measurement room isolation), and is not affected by the humidity and viscosity of the medium. The heavy hammer level gauge is not affected by the dielectric constant, conductivity, and thermal conductivity of the medium. The heavy hammer level gauge can also be used to measure special liquids such as mud, slurry, asphalt (high temperature), etc.

ULZC type heavy hammer level gauge

The main functions include:

1. Each set of equipment is equipped with multiple measurement output standards.

2. Auxiliary container level control material high-level and low-level alarm output.

3. Using intelligent self verification technology, an alarm is triggered through a fault signal when problems such as cable breakage, buried hammer, and probe locking occur during the measurement cycle.

4. Adopting the third-generation intelligent heavy hammer level gauge technology.

5. Automatic mode, manual mode, and other modes are optional.

6. The intelligent measurement control system always pulls the heavy hammer/steel cable back to its original position in an orderly programming manner. To improve measurement reliability, the return process can even be delayed.

7. The maximum measurement distance is 30 meters.

8. Using a universal 100-240VAC power supply.

9. Using magnetic Hall effect technology and microcontrollers to achieve high resolution and reliability of measurement data.

10. Built in LCD display screen and buttons, easy parameter setting.

11. The replaceable wiping block and cleaning brush keep the steel cable clean.