-
E-mail
cdysyb@163.com，@qq.com
-
Phone
18908016281，13980818230
-
Address
No. 1001, Zone A, No. 1299 Tianfu Avenue South, High tech Zone, Chengdu City
Product Categories
Chengdu Hengshengyuan Technology Co., Ltd
HT200AX anti-corrosion static pressure level gauge
NegotiableUpdate on 09/22
- Model
- Nature of the Manufacturer
- Producers
- Product Category
- Place of Origin
Overview
HT200AX anti-corrosion static pressure level gauge is mainly a new generation static pressure level gauge designed for strong acid and alkali environments. The anti-corrosion liquid level gauge is suitable for large-diameter ceramic capacitive pressure sensors, which is beneficial for preventing the condensation of corrosive liquids All sensor cables are made of high-quality corrosion-resistant materials, with a fully enclosed structure and no mechanical sealing. Application areas: Liquid levels of various conductive media such as reservoirs, sewage, bathhouses, acid-base solutions, and low-pressure boilers
Product Details
• Fully digital intelligent instrument.
• With 4 limit switch node outputs, the control domain can be set arbitrarily, and each limit can be
Set arbitrarily within the measurement range.
• The base point value can be set arbitrarily (i.e. the value or variation to be displayed on the instrument when the transmitter is at zero position)
The altitude at which the transmitter is installed.
• Standard serial RS232/RS485 digital interface; Completely isolated current and voltage output.
Pull out design, the instrument movement can be extracted from the housing for easy maintenance and replacement of the instrument
For standard transmitter signal input, the instrument can be passively calibrated on site for easy transmission
Exchange of equipment and on-site debugging
Range: 0-50 meters Accuracy: ± 0.25% FS Long term stability: ± 0.15% FS/year Temperature coefficient: ± 0.1% F.S Protection level: junction box and header: IP67 Probe: IP68 Temperature: -40~150 ℃ Relative humidity: 0~100% Analog output: two-wire system 4-20mA Power supply: 24VDC ± 10% Number of control points: 4NO (normally open)+4NC (normally closed) dry contacts Indicator lights: upper limit, upper limit, lower limit, lower limit Transmitter size: 232 × 183 × 155mm
HT200AX-TM static pressure sensor with output display box (junction box) Can be used independently, outputting 4-20mA corresponding to the liquid level Probe: PTFE+stainless steel material
Accessory diagram
Model and parameters
Remarks
HT200M on-site liquid level control display
ABS shell design
Installation requirements When installed in still water, such as deep wells or pools, the measuring part is usually directly immersed in the water for measurement. If conditions permit, the method of inserting steel pipes or PVC pipes can be used. The inner diameter of the pipe is about Φ 45mm, and several small holes are drilled at different heights of the pipe to allow water to enter the pipe smoothly. As shown in the following figure:
When installing the transmitter, the height of the storage container should be determined first, and the installation position of the transmitter and the length of the air guide cable should be determined according to the actual situation on site. Then, the transmitter should be vertically suspended at an appropriate height or installed in a bracket style, so that the transmitter is at a certain height away from the bottom to prevent sediment and dirt from blocking the pressure sensing part. The transmitter should be kept as far away as possible from the heating pipe or mixing source.
