Three axle transport beam artillery vehicle

The transport beam artillery vehicle is a prefabricated beam transport machinery designed for the construction of highway bridges. Mainly suitable for bridge construction sites, precast beam yards, etc.

Advantages of three-axis beam transport vehicle products

1. Large wheelbase, reasonable overall layout, well distributed axle load, and good stability in operation and operation

2. Private customization. Design, configure, modify, and customize according to construction requirements

3. Efficient. Good overall performance and operational efficiency

4. High quality appearance. The appearance has been fully upgraded, with a wide field of vision

Safety Operation Regulations for Transporting Beam Artillery Vehicles

Before use, the operator must check the following conditions of the moving parts of the beam transport vehicle: whether the tire pressure is sufficientWhether the engine water tank is filled with water, whether the steering wheel rotates flexibly, whether the braking device is sensitive, and whether the direction adjustment device is installedIs the device intact.

2. The roads that the beam transport vehicle passes through must be inspected, and any roadblocks should be removed in a timely manner. The impact on the road surfacePressure should be controlled, and road surfaces with pressure lower than the tire pressure of the transport truck should be reinforced in a timely manner. For uneven road sectionsIt must be filled flat to maintain the smoothness of the road surface.

When installing beams on the transport vehicle, the center of gravity of the beam should be on the longitudinal centerline of the trolley (trolley direction adjustment device)At the midpoint, the deviation shall not exceed 20mm. When installing beams on curves, the center of the beam can be aligned with the longitudinal direction of the trolleyThe centerline is slightly slanted and forms an oblique intersection. After installing the beam, it must be tied with braces and chain blocks to prevent the beam from overturning. LiangWhen the beam falls onto the trolley, a hardwood board or fiber layer rubber should be placed between the beam and the trolley support to protect the beam.

When starting during operation, slow gear must be used for startup. During operation, the heavy beam must be in low-speed gear (v ≤)15m/min)， High speed gear (v ≤ 30m/min) can be used for empty return.

5. During the operation of the beam transport vehicle, there must be a dedicated person to observe and monitor the vehicle, and any abnormal situations or incidents must be detectedThe abnormal sound should immediately notify the driver to stop the vehicle, and the operation can only continue after the fault is eliminated.

6. No debris, tools, etc. should be placed on the beams transported by the beam transport vehicle.

When feeding the beam, the beam transport vehicle must slowly drive into the rear of the beam lifting crane, and the driver must concentrate and listenAccording to the signal worker's command, the vehicle cannot collide with the beam crane.

8. After the beam crane lifts the entire beam and moves it away from the tail, it is confirmed through inspection that there are no issues around the beam transport vehicleYou can only exit the return journey after encountering obstacles.

9. The longitudinal slope of the road for tire transport vehicles shall not exceed 4%, and the transverse slope shall not exceed 3%. The path where the beam transport vehicle travelsThe road must be smooth and free of debris, ensuring that the beam transport vehicle travels smoothly and reliably to avoid puncturing the tires.